Standby
To save energy, the display and the
programme sequence/check lights
go out after 10 minutes and the
Start/Stop button starts flashing
slowly.
To come out of standby mode
^
Turn the programme selector or
press a button. Neither will have any
effect if a programme is running.
On
The standby function is activated and
the display and programme
sequence/check lights will go out after
10 minutes:
– if a programme is not selected after
the dryer has been switched on.
– after a programme has started.
They will, however, come on for 10
minutes after a delay start time has
counted down, at the end of the
programme or the end of the
anti-crease phase.
The buzzer (if selected ) will sound for
10 minutes at the end of the
programme.
Factory default. Not in current
programme
As described under "On" above.
However, the display and programme
sequence/check lights will stay on after
the programme has started and remain
visible during the programme.
Off
The display and programme
sequence/check lights will stay on while
the dryer is switched on.
Follow the steps (A,B,C ...) to
programme and store in memory.
^ See next page.
Programmable functions
56
To Next Page
Loading...
Need help?
General
