With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department. However, please note:
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages
Problem Possible cause Remedy
0-§ lights up and the
Gentle tumble check
light flashes
The electronic system
lock is activated.
You will need to
deactivate the system
lock before the dryer can
be used (see "Electronic
system lock").
0 and Finish light up
and the programme is
cancelled.
The buzzer sounds. *
This is not a fault.
The electronic unit has
recognised that there is
no laundry or insufficient
laundry in the drum and
cancelled the
programme. Drying
individual garments or
items which are already
dry can also cause the
programme to be
cancelled.
Use the Warm air
programme for drying
individual items.
The Empty container
indicator light comes on
and the programme is
cancelled.
The buzzer sounds. *
The condensed water
container is full or there is
kink in the drain hose.
–
Empty the container.
–
Check the drain hose.
* To switch off the indicator light: Open and shut the door with the dryer
switched on.
Problem solving guide
32
To Next Page
Loading...
Need help?
General