~
The tumble dryer must be isolated from the electricity supply in
the event of a fault and during cleaning and maintenance.
~
The tumble dryer must not be used in a non-stationary location
(e.g. on a ship).
~
Do not make any alterations to the tumble dryer, unless
authorised to do so by Miele.
~
Heat pump technology and refrigerant:
The heat pump in this tumble dyer uses a refrigerant which is
condensed by the compressor and led in a closed circuit through
the heat exchanger unit where heat exchange with the circulating
drying air takes place.
– The humming noises caused by the heat pump are normal and do
not impair the efficient functioning of the dryer.
– The refrigerant is not flammable or explosive.
– In general it is not necessary to leave the dryer standing for any
length of time before it is put into operation provided it has been
transported correctly (see "Installation").
However, if it has not been transported as described, ensure that
the recommended standing time prior to first operation is
observed. Otherwise the heat pump can be damaged.
~
In areas which may be subject to infestation by cockroaches or
other vermin, pay particular attention to keeping the tumble dryer
and its surroundings in a clean condition at all times. Any damage
which may be caused by cockroaches or other vermin will not be
covered by the guarantee.
Warning and Safety instructions
9
To Next Page
Loading...
Need help?
General