Anti-crease setting
Helps prevent creasing if laundry is
not normally removed immediately
after the end of a programme.
The drum will turn at intervals for two
hours after the programme has
finished.
Anti-crease
–
is set as a standard setting, can be
shortened or switched off
completely.
– can be used for all programmes,
except Woolens handcare.
– should always be switched on.
Follow steps (A,B,C ...) with the
help of the Start button and
programme selector to programme
and store in memory.
Before you begin, first ensure that:
– The dryer is switched off.
–
The door is closed.
–
The programme selector is turned to
Finish.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
C Wait until Start lights up
constantly. . .
D . . . and then release the Start button.
E Turn the programme selector to
Cottons Normal.
The Finish/Anti-crease indicator light
will flash 3 times.
The flashing Drying indicator light
shows which option is selected.
–
The Drying indicator light doesn't
flash:
Anti-crease is off.
–
The Drying indicator light flashes
once:
1 h Anti-crease.
– If the Drying indicator light flashes
twice:
Factory default settings. 2 h
Anti-crease.
F You can switch from one option to
the other by pressing the Start button
(Drying indicator light).
G Switch the dryer off.
The setting you have selected is now
stored in memory. You can alter the
settings again at any time.
Control
^
Repeat steps A to E.
^
After checking the indicator lights
(see above), switch the dryer off.
Programmable functions
42
To Next Page
Loading...
Need help?
General
