Cleaning and care
45
Checking the heat exchanger unit
Risk of injury from sharp cooling
fins.
You could cut yourself.
Do not touch the cooling fins with
your hands.
Look to see if fluff has accumulated.
If there is visible soiling:
Damage due to incorrect clean-
ing of the heat exchanger.
The dryer will not dry if the cooling
fins are damaged or bent.
Clean using a vacuum cleaner with a
dusting brush attached. Only pass
the vacuum cleaner dusting brush
over the fins lightly, without applying
any pressure.
Carefully vacuum up any visible fluff
or soiling.
Inserting the plinth filter
Fit the filter back on the handle. Make
sure it is the correct way round.
To ensure that the filter is positioned
correctly in the front of the heat ex-
changer unit:
First insert the handle with the plinth
filter attached over the two guide
pins.
– The word Miele on the handle must
be the correct way up.
Push the plinth filter in completely.
This will push in the right-hand guide
pin at the same time.
Close the heat exchanger access
panel.
To Next Page
Loading...
Need help?
General
