Cleaning and care
43
Cleaning the plinth filter
Pull the handle out of the plinth filter.
You can brush off a heavy build-up of
lint on the plinth filter or remove it
with a vacuum cleaner.
Clean the filter thoroughly under
running water.
Squeeze the water out of the plinth
filter thoroughly.
The plinth filter must not be replaced
dripping wet. This can cause a fault.
Use a damp cloth to remove any lint
from the handle.
Cleaning the plinth filter flap
Use a damp cloth to remove any lint.
Make sure that you do not damage
the rubber seal when doing this.
Check whether the cooling fins are
blocked with lint (as follows).
To Next Page
Loading...
Need help?
General