Cleaning and care
44
Checking the heat exchanger unit
Risk of injury from sharp cooling
fins.
You could cut yourself.
Do not touch the cooling fins with
your hands.
Look to see if lint has accumulated.
If there is visible soiling:
Damage due to incorrect
cleaning of the heat exchanger.
The dryer will not dry if the cooling
fins are damaged or bent.
Use a vacuum cleaner with a dusting
brush attached to clean the cooling
fins. Only pass the vacuum cleaner
brush over them lightly, without
applying any pressure.
Carefully vacuum up any visible lint or
dirt.
Inserting the plinth filter
Fit the filter back on the handle. Make
sure it is the correct way round.
To ensure that the filter is positioned
correctly in front of the heat exchanger
unit:
First insert the handle with the plinth
filter attached over the two guide
pins:
– The word Miele on the handle must
be the correct way up.
Push the plinth filter in completely.
This will push in the right-hand guide
pin at the same time.
Close the heat exchanger flap.
To Next Page
Loading...
Need help?
General