Frequently Asked Questions
Problem Possible cause and solution
flashes/lights up
after the tumble
dryer is switched
on and a program
cannot be
selected.
Access via a code has been activated.
See “Programmable functions“, “ Code”.
and light up after
a program has been
cancelled, a signal
sounds.
An excessive amount of lint has built up.
Clean the lint filters.
Clean the plinth filter.
Clean the airways: the area underneath the plinth
filter and the heat exchanger.
See “Cleaning and care”.
To switch off:
Switch the dryer off and then on again.
and another number
combination flash after
a program has been
cancelled, a signal
sounds.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program is interrupted again and an error
message appears, there is a fault. Contact Miele
Technical Service.
: lights up and the
program has been
cancelled, a signal
sounds.
The laundry is unevenly distributed or has rolled up.
Untangle the laundry and remove a few items if
necessary.
Switch the dryer off and then on again.
Start a program.
47
To Next Page
Loading...
Need help?
General