Problem solving guide
46
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Indicator lights or information on the time display triggered
when a programme is cancelled
Problem Cause and remedy
The indicator light
comes on after a pro-
gramme has been can-
celled and a signal
sounds.
The condensed water container is full or there is kink
in the drain hose.
To switch off the indicator light, open and close
the door (with the tumble dryer switched on).
Empty the condensed water container.
Check the drain hose.
See “Cleaning and care”.
The indicator light
comes on. and
flash after a programme
has been cancelled, a
signal sounds.
The system has been clogged by fluff or detergent
residue.
To deactivate the message, turn the programme
selector to the position.
Clean all fluff filters and the plinth filter.
Please see “Cleaning and care” for notes on clean-
ing.
Check that the fluff filters and the plinth filter are
free from damage and in good working order.
If all of the fluff filters are damaged, out of shape or
can no longer be cleaned, they must be replaced.
“Problem solving guide – Replacing the plinth filter”
explains when to replace a plinth filter that is no
longer in good working order.
To Next Page
Loading...
Need help?
General
