EasyManuals Logo
Home>Miele>Dryer>TWC220WP

Miele TWC220WP User Manual

Miele TWC220WP
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
11946850-00
Installation
*INSTALLATION*
Ventilation
The cool air intake at the front of the
tumble dryer must not be blocked or
covered. This would hinder a suffi-
cient intake of cool air for the heat
exchanger.
Do not block the gap between the
bottom of the tumble dryer and the
floor with plinth facings, deep pile
carpet etc. This would hinder a suffi-
cient flow of air to the tumble dryer.
The hot air that is blown out from the
heat exchanger warms the room air. En-
sure sufficient ventilation of the room:
e.g., open the window. The drying time
will otherwise take longer (higher energy
requirement).
The heat pump that is essential to
the operation of this tumble dryer
generates a great deal of heat inside
its casing. There must be a reliable
means of dissipating this heat.
Otherwise loads could take longer to
dry or the tumble dryer might sustain
damage in the long term.
Permanent room ventilation during
every drying programme and the gap
between the bottom of the tumble
dryer and the floor are mandatory re-
quirements at all times.
Before moving the tumble dryer
again
A small quantity of condensed water
that remains in the area around the
pump after the drying process can run
out if the tumble dryer is tilted. Recom-
mendation: start a programme for ap-
prox. 1minute before transporting the
dryer. Any remaining condensed water
will then be fed into the condensed wa-
ter container (which you will need to
empty again) or out through the drain
hose.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele TWC220WP and is the answer not in the manual?

Miele TWC220WP Specifications

General IconGeneral
Door hingeLeft
Door styleOpaque door
Cord length2 m
Control typeRotary
Loading typeFront-load
Drying systemHeat pump
Product colorWhite
Built-in displayYes
Reversible doorsNo
Appliance placementFreestanding
Delay start (max)24 h
Current10 A
Heat sourceElectric
AC input voltage220 - 240 V
AC input frequency50 Hz
Energy consumption1.55 kWh
Energy efficiency scaleA+++ to D
Annual energy consumption192 kWh
Cycle time165 min
Noise level66 dB
Drying classA
Drum capacity8 kg
Refrigerating mediumR290
Number of drying programs12
Refrigerating medium weight110 g
Weight and Dimensions IconWeight and Dimensions
Depth655 mm
Width596 mm
Height850 mm
Weight52000 g
Depth with door open1077 mm

Related product manuals