1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
ATLGM&EG18-EA
ATL LTE18 kit( )ATLGM&EG18-EA
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
All installation methods for mounting an access point on any wall surface are subject to the acceptance of local jurisdiction.
The Installation of the equipment must comply with local and national electrical codes.
This product is intended to be mounted outdoors on a pole. Please read the mounting instructions carefully before beginning installation. Failure to use the
correct hardware and configuration or to follow the correct procedures could result in a hazardous situation for people and damage to the system.
Use only the power supply and accessories approved by the manufacturer, which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your
own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling
requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.
This is a class A device. In a domestic environment, this product might cause radio interference in which case the user might be required to take adequate
measures.
Exposure to Radio Frequency Radiation:This MikroTik equipment complies with the European Union radiation exposure limits set forth for an uncontrolled
environment.This MikroTik device should be installed and operated no closer than 20 centimeters from your body, occupational user, or the general public.
Quickstart
Open the Ethernet port door;
Insert the SIM card into the slot, with the chip facing UP;
Connect the device to the included PoE injector with an Ethernet cable to the data+power end;
Connect the data end of the PoE injector to the computer;
Connect the power adapter to the PoE injector;
Open in your web browser;http://192.168.188.1
User name: , and there is no password
admin
(or, for some models, check user and wireless passwords on the sticker);
Enter the PIN code, if required by your mobile network operator;
Use the check for update option to upgrade the device to the latest version. You must have an active SIM card with available data;
The device will reboot;
Connect again and in the menuset a strong password.
QuickSet
To Next Page
Need help?
General
