1.
2.
3.
4.
5.
netFiber 9
netFiber 9 (
CRS310-1G-5S-4S+OUT)
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
The Installation of the equipment must comply with local and national electrical codes.
This product is intended to be mounted outdoors on a pole. Please read the mounting instructions carefully before beginning installation. Failure to use the
correct hardware and configuration or to follow the correct procedures could result in a hazardous situation for people and damage to the system.
Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your
own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling
requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik devices must be professionally installed.
Quickstart
Connect with your computer to the device;
Download the configuration tool ;https://mt.lv/winbox
Open the tab and connect to the device using MAC address;
Neighbors
Theuser name: , by default there is no password;
admin
To dupdate the device to the latest software version ownload the latest RouterOS software from ;https://mikrotik.com/download
Choose MIPSBE packages, and save them to your computer;
Return to the WinBox and upload downloaded packages;
Restart the device.
Expansion slots and ports
DC power connector 18 – 57 V.
LED indicating a power state of the device.
A number of 1G SFP ports - 5.
A number of 10G SFP+ ports - 4.
Reset button.
To Next Page
Need help?
General
