CCR2116-12G-4S+
CCR2116-12G-4S+
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
The Installation of the equipment must comply with local and national electrical codes.
This unit is intended to be installed in the rackmount. Please read the mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
This product is intended to be installed indoors. Keep this product away from water, fire, humidity or hot environments.
Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your
own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling
requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik devices must be professionally installed.
Firs Use
Connect with your computer to the device;
Download the configuration tool ;https://mt.lv/winbox
Open the tab and connect to the device using MAC address;
Neighbors
Theuser name: , by default there is no password;
admin
To dupdate the device to the latest software version ownload the latest RouterOS software from ;https://mikrotik.com/download
Choose ARM64 packages, and save them to your computer;
Return to the WinBox and upload downloaded packages;
Restart the device.
Powering
The device accepts powering from two redundant power supplies, each accepts 100-240 V AC power. You can use either, or both at the same time. Up to
60 W power consumption.
Extension Slots and Ports
12x 10/100/1000 Ethernet ports.
4x 10G SFP ports.
One M.2 slot, type PCIe x4
RJ45 console port
Mounting
The device is designed to use indoors and it can be mounted in a rackmount enclosure using provided rack mounts, or it can be placed on the desktop.
Use a Phillips screwdriver to attach rackmount ears on both sides of the device if designated use is for rackmount enclosure:
To Next Page
Need help?
General
