3. Tighten screws to secure it in place.
The IP rating scale for this device is IPX0. The device has no protection from water contamination, please ensure the placement of the device in a dry and
ventilated environment. We recommend shielded Cat5/6 cables for our devices.
Mounting and configuration of this device should be done by a qualified
person.
Configuration
The device is set up as a switch, with 192.168.88.1 as the management IP of the bridge interface. The switch supports booting RouterOS (for routing and
switching configuration) or SwOS (for only using as a switch). By default, the device will boot RouterOS, but you can reboot into the other operating system
in the following ways:
From SwOS: In the System menu, click the "Boot RouterOS" button on the bottom of the page.
From RouterOS: in the System, RouterBOARD menu, click "Settings" and there select "Boot OS".
It is also possible to select the OS and configure other boot settings via the serial console menu.
Serial console for configuration for RS-232 serial port, set by default to 115200 bit/s, 8 data bits, 1 stop bit, no parity. Standard RJ45 to COM cable can be
used. To find detailed serial console configuration and pinout please visit serial console section in our wiki pages here: https://wiki.mikrotik.com/wiki
/Manual:System/Serial_Console
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities: . In case the IP connection is not available, the Winbox tool ( ) can be used to connect to the MAC https://mt.lv/help https://mt.lv/winbox
address of the device.
For recovery purposes, it is possible to boot the device from the network, see the section.Reset button
Powering
The device accepts power from two alternative current inputs at range AC 100-240 V. Dual power supplies for redundancy with IEC power connectors.
The power consumption under maximum load can reach 60 W.
Expansion slots and ports
1x RJ45 console port (set at 115200bits/s, 8 data bits, 1 stop bit no parity).
1x 10/100Mbit Ethernet port for management access.
Eight 2.5G/5G/10G Ethernet ports.
Four 10g Ethernet / SFP+, combo ports.
One USB type-A slot.
Four cooling fans with automatic fan speed control.
Combo interface
To Next Page
Loading...
Need help?
General