3. Tighten screws to secure it in place.
The IP rating scale for this device is IPX0. The device has no protection from water contamination, please ensure the placement of the device in a dry and
ventilated environment. We recommend shielded Cat5/6 cables for our devices. The mounting
and configuration of this device should be done by a
qualified person.
Configuration
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities: . In case the IP connection is not available, the Winbox tool ( ) can be used to connect to the MAC https://mt.lv/help https://mt.lv/winbox
address of the device.
For recovery purposes, it is possible to boot the device from the network, see the section.Reset button
Powering
The device accepts power from two alternative current inputs at the range AC 100-240 V. Dual power supplies for redundancy with IEC power connectors.
DC jack input Voltage 36-57 V DC. 2-pin terminal input Voltage 36-57 V DC. PoE in input 43-57 V DC.
The power consumption under maximum load can reach 41 W.
Expansion slots and ports
Product code CRS504-4XQ-IN
CPU QCA9531 650 MHz
CPU architecture MIPSBE
CPU core count 1
Size of RAM 64 MB
Storage 16 MB, Flash
Number of 100Mbit Ethernet ports 1
Number of 100G QSFP28 ports 4
Switch chip model 98DX4310
Dimensions 320 x 185 x 44 mm
Operating system RouterOS v7, License level 5
Operating temperature -40°C to +70°C
Reset button
The RouterBOOT reset button has the following functions. Press the button and apply the power, then:
Release the button when green LED starts flashing, to reset RouterOS configuration to defaults.
Release the button when the LED turns solid green to clear all configuration and defaults.
To Next Page
Loading...
Need help?
General