MikroTik LtAP User Manual

LtAP
LtAP
The LtAP is a wireless access point with three SIM card slots for cellular data modems.
Quickstart
Please follow these quick steps to set up your device:
Unscrew two screws and remove doors to access all ports. Please see the section.Mounting
Connect your Internet cable to the Ethernet port (this is optional if using LTE as the primary connection).
Install your modem see slot usage (optional).miniPCIe
Insert the SIM card into the slot (optional) (see ).SIM card
Connect GPS antenna (optional).
Mount unit in your desired place, please see paragraph.Mounting
Choose your powering solution, please see the section for possibilities.Powering
Set your computer IP configuration to automatic (DHCP).
From your PC or smartphone, connect to the wireless network name which starts with "MikroTik".
Once connected to the wireless network, open in your web browser to start configuration, since there is no password by https://192.168.88.1
default, you will be logged in automatically.
We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version to ensure the best
performance and stability.
Choose your country, to apply country regulation settings, and set up your password on the screen that loads.
Extension slots and ports
Built-in 2 GHz wireless access point module, AP/station/bridge/p2p modes are supported. Onboard PIF antennas built-in, as well as MMCX
connectors for external antennas (software selectable).
Two miniPCIe slots and three SIM slots.
Built-in GPS module with an external SMA connector. Supports -GPS, GLONASS, BeiDou, Galileo).
Gigabit Ethernet port, supporting automatic cross/straight cable correction (Auto MDI/X). Either straight or crossover cable can be used for
connecting to other network devices. The Ethernet port accepts 12-30 V DC powering from a passive PoE injector.
One DB9 RS232 serial port for serial console access. Configured as 115200 bit/s, 8 data bits, 1 stop bit, no parity.
One USB 2.0 port for storage devices or cellular modems.

MikroTik LtAP Specifications

General

2.4 GHz	Yes
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	300 Mbit/s
Security algorithms	-
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN (RJ-45) ports	1
AC input voltage	12 - 30 V
Power consumption (max)	24 W
Product color	Black
Antenna type	Internal
Flash memory	16 MB
Internal memory	128 MB
Processor frequency	880 MHz
Operating temperature (T-T)	-40 - 70 °C
Number of products included	1 pc(s)
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	162 mm
Width	170 mm
Height	40 mm