RouterBOARD SXT Series User's Manual rev. 6
Button Index
S1400 This button has three functions. Hold the button, then apply power. Depending on when you
release the button, it will do these things:
• release immediately (0-5 seconds) after starting the device to load backup bootloader
• release when user LED starts to flash to reset RouterOS (5-10 seconds)
• release after user LED stops flashing to start Etherboot (Netinstall) mode
(10+ seconds)
RESET RouterOS reset jumper hole (RESET, marked with a black circle in the diagram above, below
S1400) – resets RouterOS software to defaults. Must short circuit the metallic sides of the
hole (with a screwdriver, for example) and boot the device. Hold screwdriver in place until
RouterOS configuration is cleared.
Ethernet Cables
RJ45
Pin
Color Function RJ45 pin for Straight cable
(MDI, EIA/TIA568A)
RJ45 pin for Crossover cable
(MDI-X, EIA/TIA568B)
1 Green TX+ Data 1 3
2 Green/White TX- Data 2 6
3 Orange RX+ Data 3 1
4 Blue - 4 4
5 Blue/White - 5 5
6 Orange/White RX- Data 6 2
7 Brown - 7 7
8 Brown/White - 8 8
Federal Communication Commission Interference Statement
(FCC ID: TV7SXT-5D)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device and its antenna must not be co-located or operation in conjunction with any other antenna or
transmitter. IMPORTANT: Exposure to Radio Frequency Radiation. 20 cm minimum distance has to be
maintained between the antenna and the occupational user and 45 cm to general public. Under such
configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be
satisfied.
10
To Previous Page
Loading...
Need help?
General
