OM-235 589 Page 6
! Never use the helmet
without the inside
and outside lens
covers properly
installed. Welding
spatter will damage
the lens and void the
warranty.
1 Helmet Shell
2 Gasket
3 Outside Lens Cover
4 Spacer
5 Lens No. 10
6 Inside Lens Cover
7 Lens Holding Frame
To remove the lens holding
frame, push down on the
frame retaining arms and
push the retaining clips
outward. Lift the assembly
and pull free of the helmet.
To replace the outside lens
cover, push the cover to-
ward inside of helmet. Re-
move the rubber lens gas-
ket and install on new lens
cover. Reinstall the lens
holding frame.
Be sure the flat side of
lens cover gasket
faces the helmet shell.
To replace the inside lens
cover, remove the spacer
from the frame by pushing
up on the two top retaining
tabs. Replace lens cover
and reinstall the assembly
in the helmet.
7
2
1
6
5
4
3
3-2. Replacing Lens and Lens Covers
805 051
To Next Page
Loading...
Need help?
General
