2
To use sublimation transfer ink with more stable quality
To prevent color change
When you print with sublimation transfer ink after you have left this machine, color may change due to color
material settling.
By shaking the ink cartridge or performing ink filling periodically, the status will be improved. (Before performing
ink filling, it is necessary to shake the ink cartridge.)
In the firmware version 5.00 and later, when the time to shake the ink cartridge or to perform ink filling has
come, a message (warning preventing color material settling) is displayed to inform you of it.
When the time to shake the ink cartridge has come (
When you use MBIS, it is not displayed.
)
When the time to perform ink filling
How to shake the ink cartridge
Holding the long side of the ink cartridge with both hands, tilt to right and left by turns to make ink flow, and
repeat it about twenty times.
• This message is displayed when the machine is in the local mode or when you switch it from the
remote mode to the local mode.
This does not terminate printing or interfere with continue printing, however, as this is not displayed
during remote mode, it is recommended to switch to the local mode by pressing the key
between printings.
• If you shake the ink cartridge too strong, it may damage the inside pack and it may cause ink leakage.
Be careful about it.
• When the cartridge is new, shake it before taking it out of bag.
• When the cartridge is in-use, be sure to wear the gloves, press waste close to the inserted side and
shake it.
• If the remaining amount of ink is less, tilt it until it becomes vertical, as you cannot shake it enough in
some cases.
• When you use MBIS, do not shake the eco case and the intermediate cartridge.
• Do not insert and pull out the intermediate cartridge as much as possible. It may cause ink leakage.
SHAKE I NK CARTR I DGE .
:
e nt
<LOCAL . 1> [ #01 ]
WIDTH:****mm
SHAKE I NK CARTR I DGE .
:
e nt
<LOCAL . 1> [ #01 ]
WIDTH:****mm
Ca r r y ou t a
[FILL UP INK] . :
e nt
When you use MBIS, this
message is not displayed.
To Next Page
Loading...
Need help?
General
