Mindray BeneHeart S1 User Manual

3 - 2
3.2.2 Environmental Requirements
The operating environment of the equipment must meet the requirements specified in this manual.
The environment where the equipment is used shall be reasonably free from noises, vibration, dust, corrosive,
flammable and explosive substances. If the equipment is installed in a cabinet, sufficient space in front and
behind shall be left for convenient operation, maintenance and repair. Moreover, to maintain good ventilation,
the equipment shall be at least 2 inches (5 cm) away from the sides of the cabinet.
When the equipment is moved from one place to another, condensation may occur as a result of temperature or
humidity difference. In this case, never start the system before the condensation disappears.
3.2.3 Connecting the Electrode Pads
1. Open the socket cover , and plug the pads connector into the pads socket.
2. Put the socket cover back. Ensure the socket cover is centered and closed.
3. Place the pads package into the pads package holders properly and carefully. Ensure the expiration date of
pads can be viewed from the pad expiration window.
4. Route the pads cable in the pad package holders.
WARNING
• Keep the pads cable connected to the equipment at all times.
• Do not open sealed pads until immediately prior to use.
• Do not bend the electrode pads forcefully.
• Make sure the pads package is intact before use. Otherwise, replace it with a new one.

Mindray BeneHeart S1 Specifications

General

Brand	Mindray
Model	BeneHeart S1
Category	Medical Equipment
Language	English

Summary

Safety Information

Dangers, Warnings, and Cautions

Highlights critical safety hazards and precautions for operating the equipment.

Equipment Symbols

Understanding Equipment Symbols

Explains the meaning of various symbols used on the equipment and in the manual.

Equipment Introduction

Overview of BeneHeart C & S Series

Introduces the BeneHeart C & S series AEDs and their general purpose.

Getting Started

Preparation and Installation Safety

Covers safety precautions and initial steps for preparing and installing the equipment.

Environmental Requirements and Pad Connection

Equipment Operation (On/Off, Language)

Using the Equipment

Operating Safety Information

Provides critical safety guidelines for operating the AED during a rescue.

Screen Display Details

Responding to a Rescue

Outlines the step-by-step procedure for responding to a cardiac emergency.

Performing CPR and Using Metronome/Sensor

Details CPR procedures and the use of CPR metronome and sensor.

Preparation for Next Rescue

Data Management

Data Management Overview

Patient Files, Configurations, and AED ALERT System

Battery Information

Battery Introduction, Safety, and Indications

Provides basic information, safety precautions, and status indications for the battery.

Battery Prompts and Replacement

Explains battery status prompts and the procedure for replacing the battery.

Care and Cleaning

General Cleaning Procedures

Maintenance and Testing

Maintenance Introduction and Safety

Emphasizes the importance of maintenance and outlines safety precautions.

Performing Maintenance and User Tests

Details recommended maintenance tasks and user test procedures.

Auto Tests, Pad Checks, and Disposal

Covers automated tests, electrode pad checks, and equipment disposal.

Technical Specifications

Safety and Environmental Specifications

Physical, Display, and Audio Specifications

Interface and Battery Specifications

Wireless and Defibrillator Specifications

ECG and Electrode Pad Specifications

Rhythm Analysis Algorithm

Methodology, Databases, and Categories

Performance Evaluation

Regulatory Compliance

Electromagnetic Compatibility (EMC)

Details compliance with electromagnetic compatibility standards.

Radio Regulatory Compliance

Outlines adherence to radio frequency regulations.

Default Settings

General Setup Options

AED and CPR Setup Options

Test and WLAN Setup Options

AED ALERT Related Setup Options

Declaration of Conformity

Product Compliance Statement

Declares the product's conformity with relevant EU directives and standards.