Cine
7-2
1 In the B, B/B or M/B mode, press <Freeze> to enter the manual cine. The [FREEZE
MENU] menu is displayed (if no menu is displayed, press <Menu>).
Note that in the B/B mode, only the window that is active when <Freeze> is pressed
has the cine.
2 If you want to perform the auto cine, press <Cine> or <Esc> to exit the manual cine.
Note:
(1) You can operate the [FREEZE MENU] menu only after exiting the manual cine.
(2) To enter the manual cine again, press <Cine>. Pressing <Cine> can switch
between entering and exiting the manual cine.
3 Perform the manual cine or auto cine. See the following contents for details.
4 You can perform post process, measurements, comments and body mark on a cine
image.
5 After all the operation is completed, press <Freeze> to unfreeze the image.
Procedure of manual cine
1
Enter the manual cine.
2 Turn the trackball leftward or rightward and the images are displayed one by one
(turning the trackball leftward can display the images in the ascending sequence of
frame No.; turning the trackball rightward can display the images in the descending
sequence of frame No.).
Procedure of auto cine
1 Exit the manual cine.
2 If you want to set speed for the auto cine, set [Speed] in the [FREEZE MENU] menu.
3 Click [Review/Stop] in the [FREEZE MENU] menu to begin the auto cine.
During the auto cine, you can modify [Speed] in the [FREEZE MENU] menu.
4 Click [Review/Stop] in the [FREEZE MENU] menu to stop the auto cine.
To Next Page
Loading...
Need help?
General
