▷ If DSC Dynamic Stability Control intervenes.
▷ If the detection range of the camera is im‐
paired, for instance by soiling, heavy pre‐
cipitation or glare effects from the sun.
▷ If the vehicle in front decelerates below a
speed of approx. 20 mph/30 km/h.
Setting the speed
Maintaining/storing the speed
Press
or button in the interrupted state.
When the system is switched on, the current
speed is maintained and stored as the desired
speed.
The stored speed is displayed on the
symbol.
DSC Dynamic Stability Control is
switched on, if necessary.
The speed can also be stored as follows:
Press button.
Changing the speed
or button: press until the desired speed
is set.
If active, the displayed speed is stored and the
vehicle reaches the stored speed when the
road is clear.
▷ or button: each time it is pressed to
the point of resistance, the desired speed
increases or decreases by approx.
1 mph/1 km/h.
▷ or button: each time it is pressed
past the resistance point, the desired speed
changes by a maximum of 5 mph/10 km/h.
or button: hold down to repeat the ac‐
tion.
Adjusting distance
Safety information
WARNING
The system does not relieve from per‐
sonal responsibility. Due to the system limits,
braking can be late. There is a risk of accidents
or risk of damage to property. Be aware to the
traffic situation at all times. Adjust the distance
to the traffic and weather conditions and main‐
tain the prescribed safety distance, possibly by
braking.◀
Reduce distance
Press button repeatedly until the de‐
sired distance is set.
The set distance is briefly displayed in
the left part of the instrument cluster.
Increase distance
Press button repeatedly until the de‐
sired distance is set.
The set distance is briefly displayed in
the left part of the instrument cluster.
Continuing cruise control
General information
An interrupted cruise control can be continued
by calling up the stored speed.
Make sure that the difference between current
speed and stored speed is not too large before
calling up the stored speed. Otherwise, unin‐
tentional braking or accelerating may occur.
In the following cases, the stored speed value is
deleted and cannot be called up again:
▷ When the system is switched off.
▷ When the ignition is switched off.
Seite 141
Driving comfort
CONTROLS
141
Online Edition for Part no. 01402983336 - X/17
To Next Page
Loading...
Need help?
General
