EN/13
Retrofit/installation kit No.: 82 83 0 136 491
Installation instruction No.: 01 29 0 139 395 Status: 06.2001
9. Concluding jobs/encoding
Connect battery.
Carry out function check.
Reassemble vehicle in reverse order of removal.
This system does not require encoding.
10. Start-up
After switching on the radio, the volume control on the radio control panel should be set to
a low volume to ensure an extremely high volume level is not set after the delayed cut-in
of the sound module amplifier!
3
The sound module is equipped with a switch-on delay facility in order to avoid damaging the audio
system.
The amplifier cuts in in full 2 - 6 seconds after switching on the radio!
Please point out these requirements to the customer when handing over the ve-
hicle.
Refer to the supplementary Operating Instructions for further information on the radio
settings to ensure optimum sound reproduction of the MINI Sound module.
To Previous Page
Loading...
Need help?
General
