EN-10
AUTO mode operation
■ Automatically selects the operation mode (COOL, HEAT, DRY) depending on the room temperature when switched on.
• If you do not want the AUTO mode program,
change to COOL, HEAT or FAN instead of
AUTO.
Page 11
• Airflow direction adjustment procedure.
Page 12
To stop: Press the ON/OFF button.
Press the MODE button.
The mode changes whenever the button is pressed.
Set to
.
Press the ON/OFF button.
Press the
or button.
Default preset temperature during AUTO mode is 24°C for both cooling and
heating mode. However, it can be adjusted (Minimum 18°C, Maximum 30°C)
using
button or button.
1
3
2
FAN SPEED
■ The FAN SPEED can be set without DRY mode.
Press the FAN SPEED button.
Each time the button is pressed, the fan speed changes.
1
• When FAN SPEED is changed from HI to LO, the sound of refrigerant
may be heard.
NOTE
Operation capacity by your choice FAN SPEED
Set automatically by microcomputer AUTO
Powerful operation with high capacity
HI
Standard operation MED
Energy-saving operation
LO
■
Each time the button is pressed, the switch over occurs in the following order
–6 → –5 → ............ –1 → ±0 → +1 ............ +6.
When +6 is indicated, even if the button is pressed, the indicator does not change.
■
Each time the button is pressed, the switch over occurs in the following order
+6 → +5 → ............ +1 → ±0 → –1 ............ –6.
When –6 is indicated, even if the button is pressed, the indicator does not change.
When it is a little cold
Press the
button.
When it is a little hot
Press the
button.
Remote Control display
-6 -5 -4 -3 -2 -1
+
0 +1 +2 +3 +4 +5 +6
18 19 20 21 22 23 24 25 26 27 28 29 30
Setting
temp.(
°C
)
• In case air is not blowing out during the
operation.
Page 21
NOTE
AUTO HI MED LO
RLC012A102_EN.indd 10RLC012A102_EN.indd 10 12/11/2017 11:26:07 AM12/11/2017 11:26:07 AM
To Next Page
Loading...
Need help?
General
