-
31
-
'10 • SCM-SM-094
(b) The unit checks the temperature every hour after the start of operation and, if the result of check is not same as the previous
operation mode, changes the operation mode.
(c) When the unit is started again within one hour after the stop of automatic operation or when the automatic operation is se
-
lected during heating, cooling or dehumidifying operation, the unit is operated in the previous operation mode.
(d) Setting temperature can be adjusted within the following range. There is the relationship as shown below between the sig
-
nals of the wireless remote controller and the setting temperature.
U
SRF series
U
SRK, SRR series
(b)
1)
2)
3)
(c)
(d)
27.5
25.5
18.0
18
30
(2)ޓSRK 20~50ZJ-S series
(a) Determination of operation mode
Heating
Dehumidifying
Cooling
Indoor air temperature (˚C)
Outdoor air temperature (˚C)
Signals of wireless remote controller (Display)
–6 –5 –4 –3 –2 –1
±
0 +1 +2 +3 +4 +5 +6
Setting
temperature
Cooling
Dehumidifying
Heating
A
(3) FDTC series
Refer to page 19.
Signals of wireless remote control (Display)
–6 –5 –4 –3 –2 –1
±
0 +1 +2 +3 +4 +5 +6
Setting Cooling
18 19 20 21 22 23 24 25 26 27 28 29 30
temperature Dehumidifying
18 19 20 21 22 23 24 25 26 27 28 29 30
Heating
20 21 22 23 24 25 26 27 28 29 30 31 32
Signals of wireless remote control (Display)
–6 –5 –4 –3 –2 –1
±
0 +1 +2 +3 +4 +5 +6
Setting Cooling
18 19 20 21 22 23 24 25 26 27 28 29 30
temperature Dehumidifying
19 20 21 22 23 24 25 26 27 28 28 30 31
Heating
20 21 22 23 24 25 26 27 28 29 30 31 32
Unit : °C
Unit : °C
To Next Page
Loading...
Need help?
General
