EN-9
Remote control handling
Replacing the batteries
The following cases show exhausted batteries. Replace old batteries with new ones.
• Receiving beep is not emitted when a signal is transmitted.
• Display fades away.
NOTE
• Do not use old and new batteries together.
• Remove the batteries when the remote control is not used for a long period.
• The recommended effective period of a battery conforming to JIS or IEC
should be 6 to 12 months with normal use. If used longer, or when an
unspecifi ed battery is used, liquid may leak from the battery, causing the
remote control to malfunction.
• The recommendable effective period is printed on the battery. This may be
shorter due to manufacturering time to the unit. However, the battery may
still be in working order after expiry of its nominal life.
Pull out the cover and take
out old batteries.
Insert new batteries.
R03 (AAA, Micro) x2
Close the cover.
■ When the display shows any abnormal condition, Press the ACL switch with the
tip of a ballpoint pen.
1
2
3
Pay attention to
the
and
marks
Press the ACL switch with
the tip of a ballpoint pen.
4
Using the remote control holder
The remote control can be attached to a wall or pillar
by using a remote control holder. Before installing the
remote control, check that the air-conditioner receives
the signals properly.
For installing or removing the remote control, move it up
or down in the holder.
Warning note for remote control handling
• Are the batteries running down?
“Replacing the batteries” above.
Replace the batteries with new ones and retry the operation.
Operation failure with the remote control
• If the operation fails, operate the unit
with temporary operation function.
Contact your dealer to have the remote
control checked.
Below
Strictly prohibited
• Do not drop the remote control.
Handle with care.
• Do not go near high temperature
places, such as an electric carpet
or a stove.
• Do not place heavy objects on the
remote control, or step on it.
• Do not put any obstructing
obstacles between the remote
control and the unit display
section.
• Do not spill any liquid on the
remote control.
• Do not leave the remote control
exposed to direct sunlight or other
strong lighting.
Temporary run operation
• The unit ON/OFF button on the unit display section operates ON/OFF temporarily when the remote control is not used.
• OPERATION MODE : AUTO
• FAN SPEED : AUTO
• Operation starts by pressing the unit ON/OFF button; it stops if you press
the button again.
• Do not hold the Unit ON/OFF button down for more than 5 seconds.
(Holding it down longer than 5 seconds sets the automatic cooling used during servicing or when relocating the air-conditioner.)
NOTE
Page 12
Operation program
Unit ON/OFF button
RJJ012A005_EN.indd 9RJJ012A005_EN.indd 9 1/18/2019 4:54:00 PM1/18/2019 4:54:00 PM
To Next Page
Loading...
Need help?
General
