EN-24
SELF CLEAN operation
■ CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moisture from inside the indoor unit and control the
growth of mold and bacteria.
1
In order to active CLEAN operation, press the CLEAN
switch with the tip of a ballpoint pen.
Every time the CLEAN switch is pressed, the display is
switched in the order of:
No display
(CLEAN on) (CLEAN off)
NOTE
• Two hours later, the air-conditioner stops CLEAN operation automatically.
To stop the air-conditioner immediately, press the ON/OFF button.
• CLEAN operation is not operated after HEAT, FAN, OFF-TIMER and
SLEEP operations have fi nished.
• The indoor unit fan runs for about two hours in CLEAN operation.
• The RUN light illuminates during CLEAN operation.
• Pressing the SLEEP button or NIGHT SETBACK button during CLEAN
operation cancels the CLEAN operation and then the unit is set to
SLEEP or NIGHT SETBACK operation.
• This is not a function for removing mold, germs or grime that have al-
ready adhered to the unit.
Auto restart function
■ What is auto restart function?
• Auto restart function records the operational status of the air-conditioner immediately prior to be switched off by a power cut, and then
automatically resumes operations after the power has been restored.
• The following settings will be canceled:
1 Timer settings
2 HIGH POWER operations
• Auto restart function is set at on when the air-conditioner is shipped from the factory. Consult with your dealer if this function needs
to be switched off.
• When power failure occurs, the timer setting is canceled. Once power is resumed, set the timer again.
NOTE
Tips for effective operation
■ Please observe the following for the most economic and comfortable use of your unit.
3 sec.
1 sec.
ON
OFF
Set a suitable room temperature.
Excessively high or low temperatures
are not good for your health and waste
of electricity.
Avoid direct sunlight and draught.
Cut out direct sunlight by drawing the
curtains or blinds when cooling. Keep
windows and doors shut, except when
ventilating.
Operate the unit only when
needed.
Use the timer properly to operate the
unit only when needed.
Clean the fi lters frequently.
Clogged fi lters may block the airfl ow and
cause less effi cient operation.
Please request cleaning of the air fi lter
from special contractor.
According to handling directions
of local arrangements part,
adjust the airfl ow direction
properly.
Adjust the up/down and left/right airfl ow
to ensure a steady room temperature.
Air fl ow direction adjustment can not be
performed by unit.
Keep heat source away when
cooling.
Keep heat sources out of the room as
much as possible.
RJJ012A005_EN.indd 24RJJ012A005_EN.indd 24 1/18/2019 4:54:01 PM1/18/2019 4:54:01 PM
To Next Page
Loading...
Need help?
General
