EasyManuals Logo
Home>Mitsubishi>Automobile Accessories>FUEL

Mitsubishi FUEL User Manual

Mitsubishi FUEL
330 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
MPI <4G6> -
Troubleshooting
13A-46
INSPECTION PROCEDURE FOR TROUBLE SYMPTOMS
INSPECTION PROCEDURE 1
Communication with MUT-
II
is not possible.
(Communication with all systems is not possible.)
Probable cause
The cause is probably a defect in the power supply system (including earth) for the
diagnosis line.
D
Malfunction of the connector
D
Malfunction of the harness wire
OK
Replace the MUT-
II
.
OK
Check trouble symptom.
NG
Check the harness wire between the
power supply and diagnostic connector
(16-pin), and repair if necessary.
NG
Repair
NG
Check the following connectors:
LHD: C-14, C-62, C-66
RHD: C-63, C-66, C-132, C-141
Measure at the diagnostic connector
(16-pin) C-20.
D
Voltage between 16 and earth
OK:
Battery voltage
OK
Measure at the diagnostic connector
(16-pin) C-20.
D
Continuity between 4 and earth
D
Continuity between 5 and earth
OK:
Continuity
NG
Check the harness wire between the
diagnosticconnector(16-pin)andearth,
and repair if necessary.
INSPECTION PROCEDURE 2
MUT-
II
communication with engine-ECU <M/T> or
engine-A/T-ECU <A/T> is impossible.
Probable cause
One of the following causes may be suspected.
D
No power supply to engine-ECU <M/T> or engine-A/T-ECU <A/T>.
D
Defective earth circuit of engine-ECU <M/T> or engine-A/T-ECU <A/T>.
D
Defective engine-ECU <M/T> or engine-A/T-ECU <A/T>.
D
Improper communication line between engine-ECU <M/T> or engine-A/T-ECU
<A/T> and MUT-
II
D
Malfunction of engine-ECU <M/T> or engine-A/T-ECU
<A/T> power supply circuit
D
Malfunction of engine-ECU <M/T> or engine-A/T-ECU
<A/T>
D
Open circuit between the engine-ECU <M/T> or
engine-A/T-ECU <A/T> and diagnosis connector
OK
Check the engine-ECU <M/T> or engine-A/T-ECU <A/T> power
supply and earth circuit system. (Refer to P.13A-68, INSPECTION
PROCEDURE 26.)
NG
Check the harness wire between engine-ECU <M/T> or engine-
A/T-ECU <A/T> and diagnosis connector.
NG
Repair
OK
Check trouble symptom.
Check the following connectors:
C-38 <M/T>, C-175 <A/T>, C-49, C-66, C-83
NG
Repair

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi FUEL and is the answer not in the manual?

Mitsubishi FUEL Specifications

General IconGeneral
BrandMitsubishi
ModelFUEL
CategoryAutomobile Accessories
LanguageEnglish

Related product manuals