EN-9
30°30°
30°30°
Operational range of the remote control
Vertical directions (ceiling mount)
Reception angle
Vertical directions
When operating the remote control, keep the distance
from the remote control to the projector via the screen
within about 5 m (15 feet). The operable range of the
remote control, however, depends on the characteristics
of the screen.
Operate the remote control
within a distance of 10 m
(30 feet) from the projector,
pointing the IR beam at the
remote control photo-sensor
(front or rear) of the projector.
Keep the remote control photo-sensor out of direct •
sunlight or fluorescent lamp light.
Keep the remote control photo-sensor at least 2 m •
(6 feet) away from fluorescent lamps. Otherwise,
the remote control may malfunction.
If there is an inverter-operated fluorescent lamp •
near the remote control, the remote control
operation may become unstable.
When you use the remote control too close to the •
remote control sensor, the remote control may not
work correctly.
Front of projector Rear of projector
Using the remote control
20°
10°
20°
10˚
20°
20°
To Next Page
Loading...
Need help?
General
