PRECAUTIONS
BEFORE
STARTING
TO
OPERATE
(1)
Safety
Precautions
1. Keep your
hands
and
fingers
away
from
the
area
around
the
needle
and
the
area
around
the
pulley
when
turning
the
power
on.
2.
Power
must
be
turned
off
when
the
machine
is not in
use,
or
when
the
operator
leaves
his/her
seat.
3. Power must be turned off before tilting the machine head, installing or
removing
the
"V" belt, adjusting
the
machine, or replacing its parts.
4. Avoid placing fingers, hair, bars etc.,
near
the
pulley, "V" belt, bobbin
winder, or motor
when
the
machine
is operating.
5. Do
not
insert
fingers
into
the
thread
take-up
cover,
under/around
the
needle, or pulley
when
the
machine
is operating.
6. Ifa belt cover, finger guard,
and/or
eye guard
are
installed, do not operate
the
machine
without
these
safety
devices.
(2)
Precautions
before
Starting
Operation
1. If
the
machine's
oil
pan
has
an oil sump, never operate
the
machine before
filling it.
2. If
the
machine is lubricated bya drop oiler, neveroperate
the
machinebefore
lubricating.
3. When a
new
sewing machine is first turned on, verify
the
rotational
direction of
the
pulley
with
the
power
on.
. (The pulley should rotate counterclockwise
when
viewed from the pulley.)
4. Verify
the
voltage
and
(single or three)
phase
with
those
given on
the
machine
nameplate.
(3)
Precautions
for
Operating
Conditions
1. Avoidusing the machine at abnormally high temperatures (35°C or higher)
or low
temperatures
(5°C or lower). Otherwise, machinefailure may result.
2. Avoid using
the
machine in dusty conditions.
To Next Page
Loading...
Need help?
General
