1-6
Chapter 1 BASIC SAFETY PRECAUTIONS
Service battery
Handle the battery correctly
Never use flames or allow sparks to
generate near the battery. The bat-
tery releases flammable hydrogen
gas and oxygen gas. Any flames or
sparks in the vicinity could cause an
explosion.
Do not use the battery when the battery electrolyte
level of which is below "LOWER LEVEL" line. Sus-
tained use of the battery could result in an explosion.
Do not short the battery terminals with a tool or other
metal object.
When removing battery, always remove the plug from
the negative (-) terminal first. When connecting bat-
tery, always connect the plug to the positive (+) termi-
nal first.
Remove all plugs, then charge the battery in a well-
ventilated area.
Make sure the cable clamps are securely installed on
the battery terminals. A loose cable clamp can cause
sparks that may result in an explosion.
Before servicing electrical components or conducting
electric welding, set the battery switch to the "Open/
OFF" position or remove the plug from the negative (-
) terminal to cut off the electrical current.
Battery electrolyte contains dilute sulfuric acid. Care-
less handling of the battery can cause the loss of sight
and/or skin burns. Also, do not consume the battery
electrolyte.
Wear protective goggles and rubber gloves when
working with the battery (when adding water, charg-
ing, etc.)
If battery electrolyte is spilled onto the skin or clothing,
immediately wash it away with lots of water. Use soap
to thoroughly clean.
The battery electrolyte can cause the loss of sight if
splashing into the eyes. If it gets into the eyes, imme-
diately flush it away with plenty of clean water, and
seek immediate medical attention.
If the battery electrolyte is accidentally consumed,
gargle with plenty of water, then drink lots of water,
and seek immediate medical attention.
To Next Page
Loading...
Need help?
General
