(2) Unit ON/OFF button
When the remote controller batteries become weak, or if the remote controller is lost or malfunctioning, this button may be
used to turn the unit on and off.
(a) Operation
Push the button once to place the unit in the automatic mode. Push it once more to turn the unit off.
(b) Details of operation
The unit will go into the automatic mode in which it automatically determines, from indoor temperature (as detected by
sensor), whether to go into the cooling, thermal dry or heating modes.
Function
operation mode
Indoor temperature
setting
Fan speed
Flap/Louver
Timer Switch
Cooling
About 24ºC
Auto Auto Continuous
Thermal dry
About 25ºC
Heating
About 26ºC
・
Model SRK20, 25, 35ZJX-S, 50, 60ZJX-S1
・
Model SRK25, 35ZJR-S, 20, 25, 35, 50ZJ-S
・
Model SRF25, 35ZJX-S, 50ZJX-S1
・
Model SRR25, 35, 50, 60ZJ-S
(3) Auto restart function
(a)
Auto restart function records the operational status of the air-conditioner immediately prior to be switched off by a power cut,
and then automatically resumes operations after the power has been restored.
(b)
The following settings will be cancelled:
1)
Timer settings
2)
HIGH POWER operations
Notes (1) Auto restart function is set at on when the air-conditioner is shipped from the factory. Consult with your dealer if this function needs to be switched off.
(2) When power failure ocurrs, the timer setting is cancelled. Once power is resumed, reset the timer.
(3)
If the jumper wire (J170 or JA1) “AUTO RESTART” is cut, auto restart is disabled. (See next page)
To Next Page
Loading...
Need help?
General
