– 15 –
Concerning CLEAN operation
1
Press the CLEAN switch with the tip of a ballpoint pen.
Each time the CLEAN switch is pressed, the indicator is switched
in the order of:
No indication
■ CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moisture from inside the indoor unit and control the growth
of mold and bacteria.
(CLEAN on) (CLEAN off)
To stop: Press the ON/OFF button.
• CLEAN operation is impossible after Heating, Fan, OFF-TIMER and Allergen
clear operations have stopped.
• The indoor unit fan runs for about two hours in CLEAN operation.
• The RUN light flashes during CLEAN operation.
Emergency run operation
• The unit ON/OFF button on the unit operates ON/OFF temporarily when the remote control is not used.
Operation program
• OPERATION MODE : AUTO
• FAN SPEED : AUTO
• AIR FLOW : AUTO
• Operation starts by pressing the unit ON/OFF button; it stops if you press
the button again.
Unit ON/OFF button
Power blackout auto restart function
■ What is power blackout auto restart function?
• Power blackout auto restart function is a function that records the operational status of the air-conditioner immediately prior to it being switched off
by a power cut, and then automatically resumes operations at that point after the power has been restored.
• The following settings will be cancelled:
1 Timer settings
2 HIGH POWER operations
• The power blackout auto restart function is set at on when the air-conditioner is shipped from the factory. Consult with your dealer if this
function needs to be switched off.
• When power failure ocurrs, the timer setting is cancelled. Once power is resumed, reset the timer.
NOTE
NOTE
RKW012A212_En.p65 11/3/05, 9:14 AM15
Black
To Next Page
Loading...
Need help?
General
