37
J. THE BACK PANEL
The Back Panel is loaded with Jacks. In addition to the Audio Outputs, there are
a multitude of CV and gate inputs, the MIDI connectors, a BNC outlet for a
gooseneck lamp, the accessory port, and the power connector.
POWER CONNECTOR: This is a standard AC power inlet, Use only a power cord
designed to mate with this receptacle. The Voyager power supply is designed to
work with power inputs of 100-240 VAC.
DANGER – Do not alter this connector in any way. Doing so can result in the
risk of shock, injury or death.
Be familiar with the safety instructions printed at the beginning of this manual.
If the connector should be damaged, refer servicing to qualified personnel
only.
MIDI CONNECTORS: These are connectors for MIDI in, out and thru.
BNC LAMP CONNECTOR: This is a 12 VDC BNC outlet for a gooseneck lamp.
CV/EXPRESSION and GATE/FOOTSWITCH INPUTS: The CV/ Expression inputs are
color coded with red nut. These jacks accept an input from an expression pedal
such as the EP-1, or a CV from –5 to +5 Volts. The Gate/Footswitch Inputs are
color coded with blue nuts.
All Gate inputs accept footswitches except the
Sample and Hold Gate Input. It accepts only a +5 Volt Gate Signal.
ACCESSORY PORT: This is designed for accessories from Moog Music – The vx-351
Voyager CV Expander It contains the output of the analog gates and CVs from
the Voyager. With the VX-351, the Voyager becomes more like a modular synth.
To Next Page
Loading...
Need help?
General
