Moog minimoog Voyager User Manual

38
K. THE USER INTERFACE/ VOYAGER SOFTWARE
1. The Interface
The interface for the minimoog Voyager’s software functions is in the center of the
instrument (figure1).
(figure 1)
The display is a LCD screen in the center. When the unit is first powered on, the screen
will read the message:
minimoog
Voyager
by moog music
The message will stay on the screen for approximately 5 seconds, then the screen will
display the Master Menu. Note that the LED above the button labeled “MASTER” is lit. The
sound produced will be the last sound used before the Voyager was powered down
previously.
There are three operating modes for the Voyager:
- MASTER: Global settings for the Voyager, and data send and receive
functions.
- EDIT: Used for editing parameters of a preset not accessed through the
front panel. Naming and saving presets is done in EDIT mode.
- PANEL: This mode accesses the Voyager’s presets and performance functions.
The Voyager contains 128 presets.

Moog minimoog Voyager Specifications

General

Brand	Moog
Model	minimoog Voyager
Category	Synthesizer
Language	English