33
ROW TWO (Continued)
VCA INPUT
Connecting a control signal to this input will raise or lower the output of the
VCA, or more simply, the volume. The control signal connected here is summed
with the output control signal of the VCA EG.
CV INPUT: 0V to +8V
ROW THREE
VCO 2 INPUT
This input accepts a 1-volt/octave control signal to modify the frequency
of VCO 2. The value of this signal is summed with the value set by the
VCO 2 FREQ knob and the individual Sequencer 2 STEP knobs.
CV INPUT: -5V to +5V
VCO 2 SUB INPUT
This input accepts a control signal to choose the value (1-16) of the VCO 2
Subharmonic Oscillators; the SUB 1 FREQ and SUB 2 FREQ (VCO 2) knobs
should be centered to receive bi-directional (+/-) control voltages.
CV INPUT: -5V to +5V
VCO 2 PWM INPUT
Connect a control voltage to this input to modulate the Pulse Width of VCO 2
and of the SUB 1 and SUB 2 subharmonic oscillators associated with VCO 2.
The Square wave must be selected using the VCO 2 WAVE switch. A connection
made here overrides the internal connection (subharmonic oscillator sawtooth 2)
used to control PWM with the VCO 2 WAVE switch in the center position.
CV INPUT: -5V to +5V
(1% Duty Cycle/Narrow Pulse to 99% Duty Cycle/Wide Pulse)
VCA EG OUTPUT
The control signal created by the VCA EG (Envelope) is available via this jack.
CV OUTPUT: 0V to +8V
THE PATCHBAY (Continued)
To Next Page
Loading...
Need help?
General
