38
USING SUBHARMONICON TO CLOCK YOUR DFAM
Use a patch cable to connect the
Subharmonicon CLOCK output jack to
the DFAM ADV/CLOCK input jack.
This will allow Subharmonicon to serve
as the clock for both units.
TIP: You can also clock DFAM by using the
Subharmonicon TRIGGER output, or the
SEQ 1 CLK and SEQ 2 CLK outputs to clock
DFAM with a polyrhythm.
Before you press the Subharmonicon PLAY button, press the RUN/STOP
button on your DFAM. This will ensure that it is ready to play when it begins
to receive the Subharmonicon clock signal.
Press the Subharmonicon PL AY button. Both units should now be playing
in sync.
SUBHARMONICON
DFAM
To Next Page
Loading...
Need help?
General
