7
Rev. 1.2
20/03/2020
SSDC-EC Hardware Manual
400-820-9661
2.1 Installing Software
Step-Servo Quick Tuner is the PC based software application used to configure, and perform
servo tuning, drive testing and evaluation of the step-servo products. System servo control gains,
drive functionality and I/O configuration are set with Step-Servo Quick Tuner. It also contains an
oscilloscope function to help set the servo control gains.
• Download the Step-Servo Quick Tuner from the MOONS
’
website and install it.
• Launch the software by clicking Start-----Programs ----MOONS
’
• Connect the drive to PC by communication cable. Please see the section below entitled
“
Choosing the Right COM Port
”
.
• Connect the drive to the Power Supply.
• Connect the motor to the drive.
• Power up the drive.
• The software will recognize your drive, display the model and firmware version and be ready
for action.
The connectors and other points of interest are illustrated below:
EtherCAT Input
EtherCAT Output
RS-232
Communication Interface
LED
EtherCAT ID
EtherCAT LED
I/O Connector
Encoder Connector
Motor Connector
Power Connector
To Next Page
Loading...
Need help?
General
