Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit • User Guide
33
590631-001-a
5.2 Installing for DirecTV (non-SWiM)
Figure 28 – DirecTV Installation (Non-SWiM)
Important! You must ensure the MoCA coaxial network is completely separate from the
Satellite coaxial network in your home. Otherwise, the Satellite Video may not function.
Follow these steps to set up the SBM1000 MoCA adapters in your home network, if you are
receiving your Internet service through a DirecTV Non-Single Wire Multi-switch (Non-SWiM)
service:
1. Identify the rooms that you want to add to your home network and make sure there is a
coaxial cable connection in each room.
2. Locate the cable wall outlet (or RF splitter) and electrical wall outlet in the first room (see
Room 1 in Figure 28).
Note: Although the SBM1100 and SBM1400 adapters are interchangeable, the SBM1400 is
typically located where more than one Ethernet connection is required (see Room 1 in Figure
28).
3. Connect one of the coaxial cables (included) to the Coax In connector on the SBM1400 and
to the RF port on the cable wall outlet (see Figure 29).
4. Connect one of the Ethernet cables (included) to one of the Ethernet ports on the SBM1400
and the Ethernet/Network port on your Smart TV or other Smart device (see Figure 29).
Repeat for each additional SBM1400 Ethernet connection with other networked audio-visual
devices, if applicable.
5. Connect one of the power adapters (included) to the Power port on the SBM1400 and plug it
into the electrical wall outlet.
To Next Page
Loading...
Need help?
General