Cloning Radio Settings
44
Cloning Radio Settings
You can copy _ Series radio settings from one radio (the source) to a second radio
using the Multi-Unit Charger (MUC) optional accessory. See the MUC User's Guide
for more information.
You can clone only one radio at a time. A multi-channel radio can clone to a single-
channel radio, but only the first channel is cloned. The MUC does not have to be
plugged in for cloning, but both radios require charged batteries.
1. On the source radio, press and hold
Push to Talk
and T for 3 seconds while
turning the radio on. The radio beeps and displays k.
2.
Place the source radio in one of the charging pockets.
3.
Turn the target radio on and place it in the charging po
cket
that is pa
ired with the pocket containing the source radio.
There are 3 paired charging pockets as indicated by the
3 pairs of charging status LEDs.
4.
Press and hold T on the source radio. The source radi
o
transmit
s its settings to the target radio. If cloning wa
s
succ
essful, P or Pass or âFâ for Fail displays on th
e source
ra
dio and the target radio displays all feature icons. If clon
ing
was not suc
cessful, F or Fail displays on the source radio.
5.
Turn the target radio off and back on again to use.
6.
To clone another radio, repeat steps 3 and 4.
7.
To exit programming mode on the source radio, press and hold
Push to Talk
until k no longer appears.
6864110W15_.book Page 44 Wednesday, April 26, 2023 2:56 PM
To Next Page
Loading...
Need help?
General
