18 Recall and dial mode
9. Recall and dial mode
Recall is useful to access certain network services and PABX /switchboard services. Your
CT2 has 2 recall buttons
1
is the short flash time and
2
is for long flash time.
NOTE
1
Short flash is 100ms / 2 Long Flash is 600ms.
Flash keys are used to refresh a dial tone. When on an external call, press R2 to access
a Call Waiting Line when a call waiting prompt signal is heard. Press again to toggle
between the two calls.
For more information about network services contact your network operator.
Your phone is set to tone dialling. You should only need to change this if connected to an
older type of switchboard / PABX which requires pulse dialling.
9.1 Change your dial mode
1. Press m, the display shows
SEt 1 dAtE
.
2. Scroll
u or d to
SEt 5 P_t
.
3. Press
m and the display shows the current setting.
4. Scroll
u or d to the change the setting.
5. Press
D to exit.
To Next Page
Loading...
Need help?
General
