16 Using Your Baby Monitor
3.11 Pair and replace extra new Baby Unit
The Baby Units and Parent Unit provided are already paired. You can add or
replace a Baby Unit in your video and audio monitoring system.
You can pair a maximum of four Baby Units to your Parent Unit. Each new Baby
Unit must be paired to the Parent Unit before use.
To pair and replace a Baby Unit:
1. Press when the Parent Unit is not in use.
2. Press
or to scroll to .
3. Press < or to choose a desired Baby Unit slot, then press O. The
pairing mode starts.
4. Turn on the new Baby Unit, and then immediately press and hold
Pair
until
the Power/Link indicator turns on.
NOTE
If you choose an occupied Baby Unit slot, the new Baby Unit will replace the
existing Baby Unit.
3.12 Multi-Camera Use
Up to 4 cameras can be paired with the Parent Unit, and if more than one camera
is linked to the Parent Unit, you can select which camera to view or set it in
Patrol
mode , where the Parent Unit automatically steps through the paired
cameras about every 15 seconds.
NOTE
The audio from a camera is only heard at the Parent Unit when that camera is
selected.
To change the camera being viewed:
Press O when the Parent Unit is in camera viewing mode to step through the
paired cameras,
1
,
2
,
3
,
4
, , with the selected option shown on the screen.
To Next Page
Loading...
Need help?
General
