Motorola ML1100 User Manual

30
19 Troubleshooting
Operation by battery
• If the power cord is not plugged into the base unit, and the battery is available the unit will
enter Battery Operation Mode. The Battery Operation Mode is designed to allow users to
continue use of the phones during a power outage and is not intended for prolonged use.
Low Battery shows in the display
• The 5 AAA batteries need replacing or are improperly installed or not installed at all.
No dial tone
• Check or repeat installation steps.
Make sure the base power cord is connected to a working electrical outlet. Make sure the
telephone line cord is connected to the base and the wall jack.
Make sure the telephone handset cord is connected to the phone and to the headset. Make
sure the cord is not damaged.
• Make sure the hook switch pops up when the handset is lifted.
• Check the s button. Make sure the indicator is o.
• Disconnect the base station from the wall jack and connect another phone to the same
jack. If there is no dial tone in the second phone, the problem might be your wiring or
local service.
Dial tone is ok, but can’t dial out
• Make sure the base station is set to the correct dial mode.
Phone does not ring
• Make sure the ringer is turned on.
• Make sure the Do Not Disturb feature is not activated.
• You may have too many extension phones on your line. Try unplugging some phones.
• See solutions for ‘No dial tone’.
• If the phone is an extension, make sure the phone is properly registered with the Motorola
ML1000 base.
You cannot be heard by the other party
• Make sure the Mute feature is not turned on.
• Make sure the handset or headset cord is inserted properly and securely.
Incoming voice too low or none at all
• Check volume setting.
You experience static, noise, or fading in and out
• Make sure the base station is not plugged into an electrical outlet with another household
appliance. If necessary, relocate the base.
Memory / Directory dialing doesn’t work
• Did you program the memory location keys correctly?
• Make sure the phone number is formatted properly.
No Caller ID
• You must subscribe to the standard Name/Number Caller ID service from your local
telephone company to receive CID information.
No display
• Make sure the unit is connected to a non-switched electrical outlet. Disconnect the power
adaptor from the base and reconnect it.

Motorola ML1100 Specifications

General

Brand	Motorola
Model	ML1100
Category	Telephone System
Language	English