Alerts
18
Scan Advance
If scan stops on a Channel that you don’t want to listen to, briefly press either the
[
and
] to resume scanning for the next active Channel.
Nuisance Delete
If scan continuously stops on an undesired Channel:
• Press and hold either
[ or ] for at least 3 seconds.
• Then release.
These steps will temporarily remove the undesired Channel from being scanned. To
restore the deselected Channel to the Scan List, turn the radio Off and then On.
You cannot remove your Home Channel from the Scan List. The Home Channel is
the Channel your radio was set to when you activated Scan.
Alerts
Channel Busy Indicator
The radio also has a Channel Busy Indicator where the LED will also flash twice per
second to indicate the Channel is in use.
Call Tone
The Call Tone obtains others’ attention before you start talking. Press
^ to allow
users using the same Channel and Code will hear your Call Tone. T5320, T5410,
and T5420 have 5 Call Tones from which to choose. Setting the Call Tone to
0
disables
^.
6864110r10o.book Page 18 Friday, December 21, 2001 11:55 AM
To Next Page
Loading...
Need help?
General
