Air Conditioner Operations and Performance
6
Page 20
mrcool.com
Three-minute protection feature
A protection feature prevents the air conditioner from being activated for approximately 3 minutes when it
restarts immediately after operation.
Air conditioner operating conditions
For proper performance, run the air conditioner under the following temperature conditions:
Power failure
Power failure during operation will stop the unit completely.
• The OPERATION lamp on the indoor unit will start flashing when power is restored.
• To restart operation, push the ON/OFF button on the remote control.
• Lightning or wireless telephone interference may cause the unit to malfunction.
Disconnect the unit with the power and then connect the unit to the power again. Push the ON/OFF button on
the remote control to restart operation.
Drying operationHeating operationCooling operationTemperature / Mode
Room temperature
62°F~90°F
(17°C~32°C)
64°F~109°F
(18°C~43°C)
20°F~109°F/-7°C~43°C
(For models with low
temp cooling systems)
64°F~126°F/18°C~52°C
(For tropical models)
64°F~126°F/18°C~52°C
(For tropical models)
32°F~86°F
(0°C~30°C)
20°F~76°F
(-7°C~24°C)
62°F~90°F
(17°C~32°C)
64°F~109°F
(18°C~43°C)
Outdoor temperature
NOTE
1.
If air conditioner is used outside of the above conditions, certain safety protection features may
come into operation and cause the unit to function abnormally.
2. Room relative humidity less than 80% - If the air conditioner operates in excess of this figure, the
surface of the air conditioner may attract condensation. Adjust the vertical air flow louver to its
maximum angle (vertically to the floor), and set HIGH fan mode.
3. Optimum performance will be achieved within these operating temperatures.
To Next Page
Loading...
Need help?
General
