Chapter 3
3-14BOIS Setup 3-15 BIOS Setup
Make U-Key at
Makes a key at the USB flash drive to prevent other people from accessing the
system. Only the user who has the key with the flash drive can access the system.
Chassis Intrusion Configuration
Press <Enter> to enter the sub-menu.
Chassis Intrusion [Disabled]
This function will be available if the chassis equips a chassis intrusion switch.
Once the chassis is opened, the system will record and issue a warning message.
To clear the warning message, set the item to [Reset], then it will return to
[Enabled] later. [Options: Disabled, Enabled, Reset]
Save & Exit
Discard Changes and Exit
Exit BIOS setup without saving any change. This it is used to abandon all changes
and exit BIOS setup.
Save Changes and Reboot
This item is used to save all changes and reboot the system.
Save Changes
This item is used to save current changes.
Discard Changes
This item is used to discard current all changes and restore to the previous values.
Restore Defaults
This item is used to restore/ load all default values by the BIOS vendor.
Boot Override
The installed boot-able devices will appear on this menu, you can select one of them
be a boot device to start booting.
▶
▶
▶
▶
▶
▶
▶
▶
▶
To Next Page
Loading...
Need help?
General
