8. Cover the load plate onto the package.
9. Press down the load lever lightly onto the load plate, and
then secure the lever with the hook under retention tab.
10. Align the holes on the mainboard with the cooler. Push down
the cooler until its four clips get wedged into the holes of the
mainboard.
11. Press the four hooks down to fasten the cooler. Then rotate
the locking switch (refer to the correct direction marked on it)
to lock the hooks.
12. Turn over the mainboard to confirm that the clip-ends are
correctly inserted.
Important:
Read the CPU status in BIOS.
Whenever CPU is not installed, always protect your CPU socket pin with the plastic cap
covered to avoid damaging.
Mainboard photos shown in this section are for demonstration of the CPU/cooler installation
only. The appearance of your mainboard may vary depending on the model you purchase.
According to the Intel North Bridge 945GZ chipset spec, this board supports CPU of FSB
800MHz at maximum by default. However, you may let your board running at FSB 1066MHz
(Core 2 Duo CPUs) by overclocking and adjusting the CPU FSB frequency in the BIOS :
Enter BIOS setup menu and go to [Frequency/ Voltage Control]à[Adjust CPU FSB
Frequency]. There you can adjust the value to [266] for the Core 2 Duo CPUs. Please be
noted that this is over-spec, and this overclocking behavior is not recommended and
not guaranteed.
Installing Memory Modules
1. The memory module has only one notch on the center and will only fit in the right
orientation.
2. Insert the memory module vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the DIMM slot. You can
barely see the golden finger if the memory module is properly inserted in the DIMM
slot.
3. The plastic clip at each side of the DIMM slot will automatically close.
To Next Page
Loading...
Need help?
General
