To Previous Page

Appendix

PBA-4

Troubleshooting

The power LED is o󰓐.

■ Press the monitor power button again�

■ Check if the monitor power cable is properly connected�

No image.

■ Check if the computer graphics card is properly installed�

■ Check if the computer and monitor are connected to electrical outlets and

are turned on�

■ Check if the monitor signal cable is properly connected�

■ The computer may be in Standby mode� Press any key to activate the

monitor�

The screen image is not properly sized or centered.

Refer to Preset Display Modes to set the computer to a setting suitable for the

monitor to display�

No Plug & Play.

■ Check if the monitor power cable is properly connected�

■ Check if the monitor signal cable is properly connected�

■ Check if the computer and graphics card are Plug & Play compatible�

The icons, font or screen are fuzzy, blurry or have color problems.

■ Avoid using any video extension cables�

■ Adjust brightness and contrast�

■ Adjust RGB color or tune color temperature�

■ Check if the monitor signal cable is properly connected�

■ Check for bent pins on the signal cable connector�

The monitor starts 󰄉ickering or shows waves.

■ Change the refresh rate to match the capabilities of your monitor�

■ Update your graphics card drivers�

■ Keep the monitor away from electrical devices that may cause

electromagnetic interference (EMI)�

Questions and Answers:

Need help?

Do you have a question about the MSI Oculux NXG252R and is the answer not in the manual?

MSI Oculux NXG252R Specifications

General