To Next Page

To Previous Page

Heater Button

- Adjust the bubble level by

pressing the button

(L1:300W, L2: 500W, L3:720W)

Bubble Button

Up Button

Filter Button

Timer Button

Down Button

Celsius/Fahrenheit

Toggle Button

Ozonator Button

Temperature display: press RESET on PRCD, read the current temperature on the screen.

Heater Button: Press HEATER button to start or stop heating.

The filter will automatically be running for 15 seconds to test the working condition once the HEATER

function is started. If there is no abnormality, the heater will keep working until water temperature

reaches the set value. When water temp goes below the set temp, the heater will restart to heat the

water automatically. The constant lighting HEATER icon means the heating system is on working

status. The flash lighting HEATER icon means the heating system is initiating or on insulation mode.

Filter Button: Press FILTER button to turn the function on/off. The FILTER icon should be

constantly lighting when the function is activated.

NOTE: Filtration cannot be turned off when heating function is on (Whether the heater is running or at

rest). When Heating function is turned off, filtration will be stopped after 30 seconds. Filtration

function can then be activated separately.

NOTE: The auto-filtration system is automatically activated every 4 hours.

Bubble Button: Can adjust among 3 levels of bubbling power. The default bubbling massage

power is at level 2 (500W). Press the BUBBLE button again, switching to level 3 (720W). Press again

to enable level 1 (300W). To shut down the function, press the BUBBLE button for 3 seconds.

NOTE: The bubbling massage function will be shut down automatically after every 20 minutes

operation for safety concern. It cannot be operated within 10 minutes after shutting down.

FILTER

HEATER

BUBBLE

ALL-IN-ONE CONTROL PANEL

mspa MONO User Manual

Questions and Answers: