mspa MONO User Manual

21
LED READING CAUSE SOLUTION
E0
E1
Water temperature is lower than 0°C
degree or exceeds 55°C (131°F)
Temperature sensor failure
Water flow switch failure
Filter failure
Water level is not at minimum water line
Contact the MSpa Service Center.
Add water above the minimum line.
Change the water or contact the MSpa
Service Center.
ERROR CODE CHART
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
NO DISPLAY ON
THE WIRED
CONTROLLER
Power failure
PRCD is off
PRCD broken
Contact the MSpa Service Center
Contact the MSpa Service Center
NOT HEATING
PROPERLY
Temperature set too low
Dirty filter cartridge
Heater failure
Filter pump broken
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact the MSpa Service Center
Contact the MSpa Service Center
Press the Reset button,
controller is not displayed
Water level is not at the minimum
water line
Reset PRCD by following PRCD Testing
section
Check power supply
BUBBLE AIR
BLOWER DOES
NOT WORK
Auto-off 10 minutes
Unidirectional threshold is not open
Control panel failure
Wait for 10 minutes
Contact the MSpa Service Center
Contact the MSpa Service Center

mspa MONO Specifications

General

Brand	mspa
Model	MONO
Category	Hot Tub
Language	English